Unsolved Resume.g activating twice With FW3.5
-
Quick question in regards to a possible behaviour change with Resume.g with FW 3.5.0 and 3.5.1
When pausing and resuming a print, the retracted filament is reinserted as double the value causing a decent blob to form as the print restarts.
By feel, the Pause.g is activating correctly and retracting the correct amount in one action. However the Resume.g is noticeably doing two separate actions of extruding the filament causing double the amount to be extruded.Its more than likely I just missed something in the firmware changelog notes for 3.5.x that affects the Resume.g.
What is interesting is when I delete the extrusion command in the Resume.g, no extrusion at all is completed, meaning a manual extrusion command is indeed required, however for now I have had to half the value for accurate re-extrusion when resuming. -
-
@Notepad are you running in standalone or SBC mode?
-
@Notepad :
I noticed this too. I had set some extraction in pause.g to resume well. Now it creates blob.
IF you resume after power fail, does it resume well for you ?
-
-