Cofiguration SZP

Esteban

Hello everyone,

I could really use some help reconfiguring my SZP probe. Currently, when I mesh the bed, I only get heights of 0, i.e. a perfectly flat plate.

I'm making my configuration files available to you.

bed.g
config.g
homeall.g
homez.g

My probe is 12.7 mm from the base of my nozzle (Z) and 35 mm in Y (the values are already configured).
What's more, I don't have a second Z probe; the homing is done with a limit switch on the Z axis. When it's triggered, the nozzle is 1.45 mm from the bed.

Similarly, the M558.2 control also has the right values.

Thank you for any help you can give me.

droftarts

@Esteban See my response to this thread, which has the same problem: https://forum.duet3d.com/post/344608

Basically, you need to calibrate the probe with M558.1. See https://docs.duet3d.com/en/User_manual/Tuning/scanning_z_probe_calibration#calibration

Ian