Duet 2 newbee

[Ernesto]

So I got hold of a 3D printer for nothing. Took me a while to figure out how to access it and how to print. Fortunally there was an SD card (worth about the same I paied for the whole lot) Those printss come out relatively nice but whatever i slice myself is coming out really strange, I seems like there is no walls and every print if like swampy and mushy, Sending the same print to an ander 3 v1 or v2 gives me nice prints but this duet 2 just gives me crapy prints...!

Any hints on cura settings?

[cosmowave]

@Ernesto Have you set cura to RRF firmware?

[droftarts]

@Ernesto See https://docs.duet3d.com/en/How_to_guides/Calibration#h-7-suggested-slicer-settings

Ian