Overheated SD card and no Temps reported
-
It sounds to me that there is excessive voltage on the 3.3V rail. Do you have anything else connected to the Duet, apart from VIN power and perhaps a USB connection and PanelDue?
-
I have the steppers and sensors. No other power sources though. Not even the USB. Just the 12v power supply
-
Do you have the hot end wiring connected, and if so, what type of Z probe (if any) are you using?
-
Hot end yes. And z probe is an npn no capacitive
-
Do you have either +3.3V (from the Z probe connector, and endstop connector or the expansion connector) or +5V going to the hot end?
-
the Z Probe is not connected just yet, the hot end is connected to E0 on its ground and VIN. and on the endstops i have the GND and end stop wires connected but not the 3.3v(the plugs used on the printrbot use only the outer 2 pins)
i followed this
https://duet3d.com/wiki/Duet_WiFi_and_Ethernet_wiring_diagrams -
I'm sorry, it sounds to me that your Duet is faulty. Please ask your supplier to replace it.
-
i purchased it directly from Duet
-
Email info at Duet3D for com then.
-
Done, thanks.
It would be awesome if there was a part of the site that would show the different model boards and people could create an overlay entry for wiring examples for different parts and/or printers.
-
We're in the process of moving to a different wiki system, which will make it easier for users to add content.
