Web Interface Freeze After Auto-Calibration

[wwmotorsports]

Hi all!

I just finished re-building my Rostock with a new Duet Wifi, 0.9° steppers, and a 24V power supply.

Everything is working perfectly and the improvement in print quality over the stock 1.8° steppers that came stock with the Rostock is incredible, especially when printing at small layer heights.

The only issue I am having is that the web interface freezes after the auto-calibration completes and tries to pull up the height map. The same thing happens if I try to load the height map and view it after reloading the web interface.

Any ideas as to what may be causing this issue?

Thanks ahead of time!

[chrishamm]

What browser and firmware versions are you using?

[Dougal1957]

that is very similar to what I am getting but only on mesh bed see my post on this running latest RC2 versions

[Gosu]

I have the same Issue everything is ok but when i Calibrate i cannot connect to my Printer but im able to print though i cannot see the status nor reconnect to the printer.

[Gosu]

sorry for hijacking this happens with Chrome Firefox and even with Edge

Runningits FW RC2
Wifi Beta10 i believe
and RC3 Webclient

[wwmotorsports]

Thanks for all of the responses and sorry for the delayed response!

I am using firmware and wifi version 1.19 and web interface 1.15a and using Google Chrome, but the same errors present in Internet Explorer as well.

It appears that I was having an occasional probing error that was causing some of the errors, and I have fixed that issue. At this point, I can run the auto-calibration and the web interface will not freeze and the G-code console will report the adjustment, but when I try to load the heightmap the web interface will still freeze.

Thoughts?

[whosrdaddy]

your web interface (DWC) version is old.
Upgrade to latest firmware/DWC version (1.20)

[wwmotorsports]

Thanks, that did the trick!