Version 3.6.0-beta 2 break scanning z probe

[PetrKroupa]

After upgrade from beta 1 scaning Z probe no longer works.

more precisely, it seems to work but it only saves every first point in the X direction.

rolled back to beta 1 and everything works.

It is conected to tool board 1LC. Mainboard Is 6HC with SBC.

; Scanning Z probe
M558 K1 P11 C"120.i2c.ldc1612" F36000 T36000
M308 A"SZP coil" S15 Y"thermistor" P"120.temp0" ; thermistor on coil
G31 K1 Z2 Y-25                                  ; define probe 1 offsets and trigger height
M558.2 K1 S22 R166864                          ; set drive current and reading offset
M557 X25:235 Y25:180 S15                      ; Define mesh grid for probe 1 (overwrites probe 0 mesh grid)

11 points probed, min error -0.286, max error -0.066, mean -0.160, deviation 0.066
Height map saved to file 0:/sys/heightmap.csv

[dc42]

@PetrKroupa thanks for reporting this issue, which I have just confirmed. I'll work on a fix.

[dc42]

@PetrKroupa please try the updated MB6HC firmware binary at https://www.dropbox.com/scl/fo/kaxbpbsyq2lxbae4tmzpk/AAPVUAh6CO_FMO-cG9ttX6U?rlkey=f0aesppc8d2p7bzwwi2s1jayo&dl=0.

[PetrKroupa]

@dc42 - I will try as soon as I get home for the evening. Thanks for the data.

[PetrKroupa]

@dc42 PERFECT. I confirm that fix si wortking.