New SZP probe board has an internal short

[Polyneutron21]

I have been using the Duet 3 scanning z probe and the third one has an internal short. I pugged in the board to the SZP per documentation and no LED lights and didn't show up in the web control. What I did notice was the temp on the hot end probe was now 2000C. I shut the Voron down and unplugged the Z probe board. I then booted it back up and the hot end was 22.8 and active. I checked the red 3.27vdc and black ground. The plug to the probe is black, red 3.3VDC, black Can low and red can High. I am using the supplied wires from the Duet 3 1LC, The other probes were working well this one hasn't worked at all. I have contacted Fila Studer and they asked me to enter it into the forum. Attached is a picture of the setup that was working.
[link text]

[Phaedrux]

Please send an email to warranty@duet3d.com and CC your reseller. Include a link to this forum thread and the details of your original purchase. You'll receive a reply with a form to fill out.