Duetwifi won't trigger endstop

[amateur_31]

Hi

I am trying to use the pinda probe (prusa z probe for mk2s) on the probe input as follows.

5v –-> 5v (from panel due connector)
gnd ---> gnd(from panel due connector)
singnal ----> IN(probe connector)

I have fitted a voltage divider to match around 1.7v then plugged that into the probe input.
I set the probe mode to be 5.

The adc does appear to register the fact that when it's triggered it logic high since on the web interface it says Z-probe : 1000 and it's red.

But when I go to the machine properties page, it says the endstop hasn't been triggered why?

I have eliminated my dodgy crimping skills by using a male to female dunpont cable.

First of all are my connections correct? if so then I need help on configuration.

now fixed it. I used configuration tool instead of just editing the config.g then it worked.