Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Disabling or changing the axis at which babystepping is applied

    Scheduled Pinned Locked Moved
    Duet Web Control wishlist
    1
    1
    22
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • ComedianTF2undefined
      ComedianTF2
      last edited by

      When using a belt printer, the slicer and thus the printer is setup using the Z axis as the belt axis, while the Y axis is the up/down movement.

      Now, it's possible to babystep using M290 Y<value>, and when sending these commands everything works all fine and dandy

      However the default paneldue (7i) or web interface babystepping buttons are set to always apply the babystepping to the Z (belt) axis.

      Is it possible to adjust the default babystepping axis? I was thinking of maybe using the daemon.g to translate the Z babystepping into Y babystepping, but I'm not really happy with that idea as there would be significant delay between the babystepping is applied and it getting applied on the correct axis.

      1 Reply Last reply Reply Quote 1
      • Phaedruxundefined Phaedrux moved this topic from General Discussion
      • First post
        Last post
      Unless otherwise noted, all forum content is licensed under CC-BY-SA