Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Magnetic Roller Filament Sensor V4

    Scheduled Pinned Locked Moved Solved
    Duet Hardware and wiring
    2
    3
    120
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • JADoglioundefined
      JADoglio
      last edited by

      No issue just curious what is going on here.

      I have a magnetic rolling filament sensor I bought a while back. There is a sticker on it that says it is a V3. When I run M591 D0 I get the following report.

      Duet3D magnetic filament monitor v4 on pin io5.in, enabled always, 28.80mm/rev, allow 60% to 160%, check printing moves every 3.0mm, mag 130 agc 46, measured 24.68mm/rev, min 15% max 3011% over 2225.2mm.

      Is it a V4 or a V3. If it is V3, why is it reporting V4.

      Thanks for any help I get here.

      dc42undefined 1 Reply Last reply Reply Quote 0
      • dc42undefined
        dc42 administrators @JADoglio
        last edited by

        @JADoglio the firmware has gone through 4 revisions, the hardware through 3.

        Duet WiFi hardware designer and firmware engineer
        Please do not ask me for Duet support via PM or email, use the forum
        http://www.escher3d.com, https://miscsolutions.wordpress.com

        JADoglioundefined 1 Reply Last reply Reply Quote 0
        • JADoglioundefined
          JADoglio @dc42
          last edited by

          @dc42 Thank you.

          1 Reply Last reply Reply Quote 0
          • dc42undefined dc42 marked this topic as a question
          • dc42undefined dc42 has marked this topic as solved
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA