Better rejection of unsupported files
-
Made the mistake of uploading an STL instead of a .GCODE file.
The duet rightly complained that this file made no sense.
I then had to go to the printer and press STOP to get it to reset and made it possible for the web browser to connect.
I would really like a more graceful version of error handling for the fault: "Stupid user"… (
) Since I will probably cause it again... -
Amen.
-
The newer versions of DWC by default limit the file you can upload unless you click 'All Files' in the upload window.
-
Yep, made that mistake too. After upload the web interface just disconnected for no obvious reason and i couldn't connect back. Did a reset and uploaded again for like 5 times before realising that my slicer saved the gcode to different directory
