Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

RPM fan is proportional to temperature

Locked

General Discussion

2

5

652

Log in to reply

undefined

parovoZZ
last edited by

Hi!

Is it possible to control the fan speed in proportion to the temperature of the extruder?
1 Reply Last reply
Reply Quote 0
undefined

dc42 administrators
last edited by

Yes, look up M106 in the GCodes page of the wiki.
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com
1 Reply Last reply
Reply Quote 0
undefined

parovoZZ
last edited by

Just now the fan on 40% at a temperature of 50 C. I do not know how to make an example:
200 С -> 40%
220 С -> 50%
….
260 C -> 100%

To use several M106 commands?

Thanks!
1 Reply Last reply
Reply Quote 0
undefined

dc42 administrators
last edited by

M106 Pnn Hnn L40 S1 T200:260
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com
1 Reply Last reply
Reply Quote 0
undefined

parovoZZ
last edited by

OK
Thanks!
1 Reply Last reply
Reply Quote 0

1 / 1