Z homing during print
-
Just installed a replacement Duet Wifi board tonight. Ran through the configuration and everything moves as it should and is accurate.
I loaded a 20x20mm calibration cube that I’ve used on this printer when I was using a ramps board. I can move all the Axis properly, I can “home all” no problem. But when I try and print, the Z axis wants to go back to the Home height. I did move it +1mm in the web control during a print and it does move, but as soon as the next layer goes to print, the Z axis goes back to the home height and it Tries to keep printing at the lower height, not higher like it’s supposed to.
-
You asked the same question in another thread, and I have replied there.
