Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Extruder d0 got shorted and is dead

Locked

Duet Hardware and wiring

2

3

439

Log in to reply

undefined

stavrosgmtl
last edited by 19 Feb 2018, 17:10

D1 is fine. Is there something I can test or replace on board?

Cheers
Stav
1 Reply Last reply
Reply Quote 0
undefined

dc42 administrators
last edited by 19 Feb 2018, 17:34

Do you mean the motor output, or the heater output? If the heater outputs got shorted, the hearter mosfet needs replacing. If the motor output got shorted. the TMC2660 driver chip needs replacing.
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com
1 Reply Last reply
Reply Quote 0
undefined

stavrosgmtl
last edited by 19 Feb 2018, 21:38

Motor. TMC2660 ack..

Thank you for the help
1 Reply Last reply
Reply Quote 0

1 / 1