Call end.g when sdcard file completes

[TickTock]

Although slicers will automatically add pre and post code, I would like the firmware to automatically call a macro upon completion of the print.

[Phaedrux]

You can create a file called end.g and then call it with the M98 command from your slicer end code.

https://duet3d.dozuki.com/Wiki/GCode#Section_M98_Call_Macro_Subprogram

So add M98 end.g to the slicer end code.

Then add whatever you want to end.g

[dc42]

It already calls stop.g if your file ends with command M0.

[TickTock]

Thanks. And thanks. I suspected there must be already a solution.