BL Touch Configuration
-
Tried adding the I1 to the M558, still nothing. The bltouch doesnt make any sounds.
Running M307 H3 returns "Heater 3 is disabled"
-
Probably a wiring issue then.
-
I've checked the wiring multiple times and even tried a buddies known working bltouch.
-
You could try heater pin 7 instead of 3. See if that makes a difference for you.
-
Can you confirm that you are running with VIN power applied and the internal 5V regulator is enabled?
-
The jumper is on the internal 5v pins, and Vin LED illuminated.
-
Can you post a photo showing how the bltouch is connected to the Duet?
-
Heres a closeup of the wiring. https://ibb.co/e1hqkS
-
The wiring looks OK to me and I didn't spot anything wrong with the commands you are using. The +5V and ground connections must be more or less OK if the bltouch self test works and the red light comes on. So it's either a problem with the orange control wire, or with the heater 3 output on the Duet. When you tried your friend's bltouch, did you use his cable too?
-
Sorry its taken me so long to reply, Ive been quite busy and haven't had much time for the printer. The BL touch is now working. I tried a new wire and sure enough, that was it. Thank you for all the help, its been greatly appreciated.
