add two nema 23 in series
-
Can I add two nema 23 in series in Z axis and in Y axis.
2.2A and 2.6 ohms each motor . thanks -
You could use an extra driver to make a second Zaxis. I have 4 on mine.
-
Series takes same current, but cuts torque at each motor in half. (EDIT: Torque is same at low speeds; the downside is the speed at which torque begins to fall off is halved)
Parallel draws double current (quite often beyond capacity of a single driver).
Best way on Duet is almost always to use one driver per motor, and configure to make them work together.
-
@danal said in add two nema 23 in series:
Series takes same current, but cuts torque at each motor in half.
Parallel draws double current (quite often beyond capacity of a single driver).
Best way on Duet is almost always to use one driver per motor, and configure to make them work together.
No, series gives you the same torque at low speeds - unless the motors have unusually high resistance - but the maximum speed you can run the motors at before the torque starts to drop is halved. There is a calculator at reprapfirmware.org to work this out.
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com -
@dc42 said in add two nema 23 in series:
@danal said in add two nema 23 in series:
Series takes same current, but cuts torque at each motor in half.
Parallel draws double current (quite often beyond capacity of a single driver).
Best way on Duet is almost always to use one driver per motor, and configure to make them work together.
No, series gives you the same torque at low speeds - unless the motors have unusually high resistance - but the maximum speed you can run the motors at before the torque starts to drop is halved. There is a calculator at reprapfirmware.org to work this out.
Aha! Thank you... I almost didn't post that, something didn't quite feel right.
Excellent clarification.
