M203 Max Speed
-
M203 Max speed, does this override the Default Printing Speed in the Simplify3D slicer?
-
Let me change how I asked the question:
What settings do I need to change so I can speed up my Delta printer. Are these settings in both Slicer and Duet firmware?
One of the reasons i built a Delta was for speed and size of prints.
I have a Qidi Tech X-One (Cartesian) which prints at the same speed as the Delta I built. -
The M203 setting is the never-exceed-speed. So it should be higher than your printing speed and travel speed settings in slic3r. A typical value for a delta would be 12000mm/min i.e. 200mm/sec. Don't set it so high that your printer starts to skip steps when you command movement at maximum speed.
