Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Strange corner on cube

    Scheduled Pinned Locked Moved
    General Discussion
    2
    5
    816
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Monster Deltaundefined
      Monster Delta
      last edited by

      Not really a duet problem but there are some really clever people here that im hoping can help me heres my problem. 0_1526675650171_received_10156431794344592.jpeg Im getting this really strange result when printing a cube. All the corners are nice and sharp except this one and its got me baffled. When looking closely it looks like the corner is trying to curl up but its fine at the bottom and at the top and the bottom0_1526675661881_received_10156431794509592.jpeg

      Hergonowayundefined 1 Reply Last reply Reply Quote 0
      • Hergonowayundefined
        Hergonoway @Monster Delta
        last edited by Hergonoway

        @monster-delta

        lack of cooling. Increase cooling or reduce speed print if it's already cooled. The fact that it's only on 1 corner is certainly due to the pattern your slicer made or if you've got something like reaction between layer and retraction settings a bit too low it could stall the hotend to this corner for too long.

        Delta goes BrrrRRRRrrrrrRRRRrrr

        1 Reply Last reply Reply Quote 0
        • Monster Deltaundefined
          Monster Delta
          last edited by

          Hi I'm already printing at 190° the print is being cooled and I've tried printing slower but it makes no difference. If it was due to heat or cooling wouldn't i see it on all 4 corners. The retraction is done on the opposite corner

          1 Reply Last reply Reply Quote 0
          • Hergonowayundefined
            Hergonoway
            last edited by Hergonoway

            what's the orientation of your cooling fan compare to this corner ? did it run at 100% ?

            I've printed a test cube 2 weeks ago while re-working my cooling and I had exactly the same effect.

            Try to print it again but rotate the piece by 45 degree, if it cooling orientation you'll see it right away.

            Delta goes BrrrRRRRrrrrrRRRRrrr

            1 Reply Last reply Reply Quote 0
            • Monster Deltaundefined
              Monster Delta
              last edited by

              Ok got it sorted turns out the fan was cutting out as the nozzle aproached that corner and kicking back in as it moved away due to a loose wire

              1 Reply Last reply Reply Quote 1
              • First post
                Last post
              Unless otherwise noted, all forum content is licensed under CC-BY-SA