Driver Stall Warning while Simulating

[wilriker]

I have all my drivers setup for stall detection to report a message. My X and Y are somewhere above S10 but Z and E0 are still at the default S1. While in simulation mode I get stall warnings for Z and E0 all the time.

How is that even possible?

P.S.: When I start a print I will also immediately get a stall warning for E0 at the current Z-height. If that is relevant: motors have been turned off by M18/M84 after last print.

[dc42]

Which firmware version are you running?

[wilriker]

@dc42 Sorry, forgot to add this

Firmware Name:	RepRapFirmware for Duet 2 WiFi/Ethernet
Firmware Electronics:	Duet WiFi 1.02 or later
Firmware Version:	2.0(RTOS)RC2b (2018-05-13b3)
WiFi Server Version:	1.21
Web Interface Version:	1.21.1-RC4

EDIT: I just upgrades to 2.0RC4 and it still happens.

[dc42]

Thanks for your report. I have put a new firmware binary (RC4a) in the EdgeRelease folder at https://github.com/dc42/RepRapFirmware/tree/v2-dev/EdgeRelease. Please try it. It should fix the stall warnings when simulating, but I'm not sure about the other ones.

[wilriker]

@dc42 Fix confirmed for simulation - I will see if it also fixes the warning at the start of a print later.

Another question: do you prefer reporting issues here or at Github?

[dc42]

I generally prefer issues to be reported here, especially for beta and release candidate firmware.

[wilriker]

@dc42 OK, I will then keep reporting them here.