Expansion stepper Breakout + TB6600
-
I connected the Expansion stepper Breakout to my Duet Wifi, I wired my Tb6600 Stepper, i remapped the Z Axis but nothing happened, my Nema doesn't move.
I need to connect 4 Tb660 to connect my 4 Nema to move the Z axis of my Big Printer.TB6600--->Expansion Board
ENA- --> E-
ENA+ --> E+
DIR- --> D-
DIR+ --> D+
PUL- --> S-
PUL+ --> S+I connected VCC and GND to 12v on my PSU
-
Those connections look correct to me. How did you remap the Z axis? Did you get any error messages when you tried to jog the Z axis?
-
i used M584 Y2 Z5:6:7:8
When i try to move Z axis stepper motor doesn't move and i didn't get any message
-
Did you use the T parameter in the M569 commands for the external drivers, to increase the step pulse width? Most external drivers need this.
-
I've Tried with M569 P5 R1 T3 but nothing change
-
I've mesured with the multimeter Dir - e dir+ and it says +3.3V when i go "up" and -3.3V when i go "down". but my stepper motor doesn't move
-
M569 P5 R1 T2.5:2.5:5
now i've used this command and all worked fineTy for all the Help!