Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Reconfiguring WiFi Connection

    Scheduled Pinned Locked Moved
    General Discussion
    2
    6
    1.6k
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • DebugBearundefined
      DebugBear
      last edited by

      Right, I got a new router so I need to reconfigure my DuetWifi to connect to it. Since it can't see the original SSID, the DuetWifi goes into access point mode (good). When I connect to the DuetWiFi AP I have the following problem:

      Basically my IP address is way out of range. I have tired setting my IP manually to 192.168.1.100, mask to 255.255.255.0 and gateway to 192.168.1.1. I've also tried resetting the DuetWiFi multiple times. Am I missing something? Is there a way to do a "factory reset"? I may take this opportunity to move up to the 1.15c firmware.

      1 Reply Last reply Reply Quote 0
      • dc42undefined
        dc42 administrators
        last edited by

        Looks like your Windows PC has failed to get an IP address via DHCP. Have you tried runing "ipconfig /renew" from a command prompt?

        Duet WiFi hardware designer and firmware engineer
        Please do not ask me for Duet support via PM or email, use the forum
        http://www.escher3d.com, https://miscsolutions.wordpress.com

        1 Reply Last reply Reply Quote 0
        • DebugBearundefined
          DebugBear
          last edited by

          Just tried that, it hangs:

          [c]PS C:\Users\James> ipconfig /renew WiFi
          Windows IP Configuration[/c]
          After approx 5 minutes, Ctrl + C
          [c]An error occurred while renewing interface WiFi : unable to contact your DHCP server. Request has timed out.[/c]

          Unfortunately the baby is asleep in the same room at the moment, so I can't connect via USB right now! Kids, eh?

          1 Reply Last reply Reply Quote 0
          • DebugBearundefined
            DebugBear
            last edited by

            I now have physical access! Connected over USB serial, restarted the web server (M552 S0 followed by M552 S1), connected and it all worked as expected. Not sure why rebooting the whole board did not do this… Happily up and running again though 😄 Thanks for your time dc42.

            1 Reply Last reply Reply Quote 0
            • dc42undefined
              dc42 administrators
              last edited by

              Glad you got it working. When you tried "rebooting the whole board" previously, was that by powering off/on or by pressing the reset button?

              Duet WiFi hardware designer and firmware engineer
              Please do not ask me for Duet support via PM or email, use the forum
              http://www.escher3d.com, https://miscsolutions.wordpress.com

              1 Reply Last reply Reply Quote 0
              • DebugBearundefined
                DebugBear
                last edited by

                Powering off and on again. USB disconnected, turning ATX PSU off at the wall, then back on again.

                1 Reply Last reply Reply Quote 0
                • First post
                  Last post
                Unless otherwise noted, all forum content is licensed under CC-BY-SA