Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Z Probe setup for a fresh install

    Scheduled Pinned Locked Moved
    Tuning and tweaking
    3
    4
    518
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Crestyundefined
      Cresty
      last edited by

      Hi, i did all the installation required to have bltouch running. (Im using a Tevo Little Monster)
      As i powerup the printer it does its test and after it it gets his red light stable on.
      Z probe on sensors is reading 0 as a value.
      How can i test it to prove it is actually working?? Whats the g-code to move the pin in and out?

      1 Reply Last reply Reply Quote 0
      • Bennyundefined
        Benny
        last edited by

        Alarm Release + Pin UP
        M280 P7 S160 I1 ; Alarm Release and Push-Pin UP
        Pin Down
        M280 P7 S10 I1 ; Send PWM channel 7 the s10 (angle) command
        Pin Up
        M280 P7 S90 I1 ; Send PWM channel 7 the S90 (angle) command
        Self-Test
        M280 P7 S120 I1; Send PWM channel 7 the S10 (angle) command

        1 Reply Last reply Reply Quote 0
        • Bennyundefined
          Benny
          last edited by

          change to P7 to P3 if using heater 3

          1 Reply Last reply Reply Quote 0
          • Phaedruxundefined
            Phaedrux Moderator
            last edited by

            Have you seen this? https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe#Section_BLTouch

            Z-Bot CoreXY Build | Thingiverse Profile

            1 Reply Last reply Reply Quote 0
            • First post
              Last post
            Unless otherwise noted, all forum content is licensed under CC-BY-SA