Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Question about delta cal using bed.g [SOLVED]

Tuning and tweaking

2

3

344

Log in to reply

undefined

fcwilt
last edited by fcwilt

Hi,

M666 sets the endstop adjustments.

Do these settings need to be zeroed before running the auto-cal procedure?

Thanks.

Frederick
Printers: A FT-5 with the 713 upgrade bits, a custom MarkForged style, a small Utilmaker style, a small CoreXY from kit and a E3D MS/TC setup. Various hotends. Using Duets (2 and 3) running 3.4.6
1 Reply Last reply
Reply Quote 0
undefined

dc42 administrators
last edited by

They do not need to be zeroed.
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com
undefined 1 Reply Last reply
Reply Quote 0
undefined

fcwilt @dc42
last edited by

@dc42 said in Question about delta cal using bed.g:

They do not need to be zeroed.

That is good to know.

Frederick
Printers: A FT-5 with the 713 upgrade bits, a custom MarkForged style, a small Utilmaker style, a small CoreXY from kit and a E3D MS/TC setup. Various hotends. Using Duets (2 and 3) running 3.4.6
1 Reply Last reply
Reply Quote 0

1 / 1