Fan assignment to tool, no thermocouple?
-
Hello,
I use Heater 2 for chamber on the duet wifi and connect Fans to P2 output.
Can I do that when I turn on heating the fan switches on immediately and when turn off heating the fan shuts down.?
But i need to do this on the P2 fan output, so that I can restrict the speed ,,F250,,I tried different combinations like ,,M106 P2 H2,, ,,M563 P2 D2 H2 F2,, and others. I tried to assign but fan no react.
-
Which Duet are you using?
-
Duet 2 Wifi New version v1.04
-
The correct command is M106 P2 H2 Tnn where nn is the temperature at which you want the fan to turn on. You can also add an S parameter to limit the fan speed, although for thermostatic fans the firmware enforces a minimum S0.5.
