Error: Heating fault on heater 0. (Solved!)
-
Hello everyone.
When I try to start print my bed heater always has fault.
Error: Heating fault on heater 0, temperature rising much more slowly than the expected 0.1°C/sec
But when it heated, all work good and have good Temperature nChart.
Of course I made pid control before...approx 6 month ago...
I have silicone heater + SSRIn config:
M305 P0 T100000 B3950 R4700 H30 L0 ; Set thermistor + ADC parameters for bed thermistor
M143 H0 S130 ; Set temperature limit for heater 0 to 130C
M570 S190 ; Hot end may be a little slow to heat up so allow it 190 seconds
M307 H0 A245.8 C1264.3 D2.0 S1.00 V24.6 B0
-
@spax said in Error: Heating fault on heater 0. + Bad Temperature Chart.:
M305 P0 T100000 B3950 R4700 H30 L0
Solved! I delete H30 L0 and now all work well.....hmm...I don't even remember where it came from.
