What is Jerk setting called in RepRap?
-
Hi Guys! I seem to be getting differing opinions on facebook. In the duet config.G, where do I adjust Jerk settings? What exactly is it called in config? I see nothing called "Jerk" as I normally see in Marlin. What parameter controls jerk in reprap? Thanks!
-
-
Example:
M566 X900.00 Y900.00 Z12.00 E120.00 ; Set maximum instantaneous speed changes (mm/min)
Edit:
Beware that these changes are in mm/min! -
Also added in either RRF 2.01 or 2.02 is (the still undocumented)
M205
which sets the jerk/instant deviation in mm/s as it is done in Marlin based firmware. -
@wilriker said in What is Jerk setting called in RepRap?:
Also added in either RRF 2.01 or 2.02 is (the still undocumented)
M205
which sets the jerk/instant deviation in mm/s as it is done in Marlin based firmware.Now documented. M205 is supported from firmware 2.02. Only the XYZ and other axis parameters are supported, other parameters will be ignored.