• Tags
  • Documentation
  • Order
  • Register
  • Login
Duet3D Logo Duet3D
  • Tags
  • Documentation
  • Order
  • Register
  • Login

Strange extrusion

Scheduled Pinned Locked Moved
Tuning and tweaking
3
5
517
Loading More Posts
  • Oldest to Newest
  • Newest to Oldest
  • Most Votes
Reply
  • Reply as topic
Log in to reply
This topic has been deleted. Only users with topic management privileges can see it.
  • undefined
    Tef9
    last edited by 9 Feb 2019, 15:01

    Hi there,

    I managed to upgrade my volcano to use the Nozel X. While doing this I found a lot of issues with the hot end. Its taken time but I am back to printing. I have enabled retraction in the firmware not via sic3er. I had some problems with retraction which are now sorted, however I have an interesting issue and am stumped as to what it could be.

    The printer is printing as normal, then without warning it stops and the extruder runs for about two second solidly. As a result I get puddle points as in the picture attached. Is this a retraction problem? I don't know where to look to resolve this problem.

    0_1549724402622_thumbnail.jpg

    As ever any advice would be well received.

    Best,

    Andy

    1 Reply Last reply Reply Quote 0
    • undefined
      Wyvern
      last edited by 9 Feb 2019, 16:53

      Any move errors under M122?

      1 Reply Last reply Reply Quote 0
      • undefined
        Tef9
        last edited by 9 Feb 2019, 18:09

        Hi,

        Good thinking, sadly nothing is shown.

        Best,

        Andy

        1 Reply Last reply Reply Quote 0
        • undefined
          Phaedrux Moderator
          last edited by 9 Feb 2019, 18:10

          Can you post your config.g and an example of gcode file that has this problem?

          Do you have extra prime amount set in your retraction command?

          Z-Bot CoreXY Build | Thingiverse Profile

          1 Reply Last reply Reply Quote 0
          • undefined
            Tef9
            last edited by 9 Feb 2019, 18:59

            Solved it 🙂

            Pressure advance was set in slicer as well as in the firmware, removed the slic3er entry (it was set to 1) and all is well.

            Fantastic, thanks for the reply's and suggestions.

            Have a great evening.

            Andy

            1 Reply Last reply Reply Quote 0
            4 out of 5
            • First post
              4/5
              Last post
            Unless otherwise noted, all forum content is licensed under CC-BY-SA