Z +- 0.05 or 0.1 not available via phone web control

[CozyP]

Hi all,

I was using an old duetwifiserver file and I changed to the latest one, 1.22. I noticed that when I try to control Z axis through web on my phone ( iOS safari ) only +- 0.5, +-5 and +-25 are available.
This is kinda nuisance when try to position the Z axis manually before the start of every print, as the 0.5 movement is HUGE.
Is there any possibility to change this manually?

Thank you for your time!

[Phaedrux]

What version of DWC and firmware are you using?

You should be able to specify the baby stepping amount in Settings > User Interface tab.

https://duet3d.dozuki.com/Wiki/Duet_Web_Control_Manual#Section_User_Interface

[CozyP]

I didn\t know that you could change the values with right click. DAYUM!!!
Thanks

[NeoandGeo]

Also when you change one side with right click, the other side reflects the change too.