Can I get verification on the wiring before I turn in back on.
-
@hbrownell On the micro switch, use C & NC. On the Duet, connect to the two outer endstop pins, don't use the center pin.
-
what is the resistance between the red and blue wire of the motor?
measure it with the cable connected to the motor and disconnected from the duet. -
@stephen6309 And on the Duet board?
-
This post is deleted! -
@veti I just re-read your comment. So, I get 2000 on both phases from the motor if I'm doing this right. I'm not entirely certain I understand what you're asking me to do. I'm still learning.. ( A lot )
-
@hbrownell said in Can I get verification on the wiring before I turn in back on.:
Okay, so I verified that the colors on the chart and on the stepper diagram are in sync. I first up the board, no smoke.. good sign.. I clicked on the Home X and got this.
G28 X
Warning: motor phase A may be disconnected reported by driver(s) 2
Warning: motor phase B may be disconnected reported by driver(s) 2Next step?
Driver 2 is the Z motor. What Z motor or motors do you have, and how have you connected them to the Duet?
-
I just have the X and Y connected.
-
Here's another diagram of how I have things connected and the supporting material from the manufactures.
-
@veti Hey man, I just got it sorted on the endstops. I notice that the indicator light triggers as I flip the switch, so it's not that. It's the steppers and whatever else I got wrong lol. Thanks for the input!
-
@hbrownell said in Can I get verification on the wiring before I turn in back on.:
I just have the X and Y connected.
the homing moves the z down by 5mm. so if you did not connect your z thats where the message comes from.
-
This post is deleted! -
@veti I'm not clicking home all, just X or Y. Does that account for this?
-
yes all default homing from the configurator do that.
-
This post is deleted!
