Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    Use the stallguard feature to figure out max. acceleration?

    General Discussion
    1
    1
    388
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • r123
      r123 last edited by

      Having read up the on the Stallguard feature of the TMC2660 drivers, wonder if there's a way to make use of it.

      In particular, how about a test routine which performs a series of increasingly rapid accelerations on the various axes?

      The objective would be to monitor the output from the Stallguard, perhaps to determine what acceleration demands 80% of maximum torque of each motor (the masses, frictions, leverages etc associated with each axis are going to be different).

      These figures might then inform the selection of acceleration parameters for the 3d printer in question.

      1 Reply Last reply Reply Quote 1
      • First post
        Last post
      Unless otherwise noted, all forum content is licensed under CC-BY-SA