G31 Z height and babystepping



  • Hi,
    I have in G31 a Z height about 1.74mm, and during the first layer le nozzle hit the bed.
    I have to set babystepping to -0.5mm in order to have a good nozzle height.
    So, in G31, I have to add or substrate the babystepping value ?

    I think substrate, because the Z height have to be higher, so 1.74mm + 0.5mm = 2.24mm.

    I am right ?


  • administrators

    Increasing the G31 Z parameter (or making it less negative, if it is negative) will move the nozzle closer to the bed.


Log in to reply