Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    Double mapped fans not controllable

    General Discussion
    2
    3
    180
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • gnydick
      gnydick last edited by

      I have two blowers connected that are both mapped to both tools. I completed the first print since setting this up and when it was finished, I couldn't turn the fans off or change their speed.

      M563 P0 S"Left" D0 H1 F3:4
      M563 P1 S"Right" D1 H2 F3:4
      
      1 Reply Last reply Reply Quote 0
      • dc42
        dc42 administrators last edited by

        How were you trying to turn them off?

        • If tool 0 or tool 1 was selected, then M106 S0 should have worked.
        • If neither tool was selected, then you would have needed to send M106 P3 S0 and M106 P4 S0.

        Duet WiFi hardware designer and firmware engineer
        Please do not ask me for Duet support via PM or email, use the forum
        http://www.escher3d.com, https://miscsolutions.wordpress.com

        gnydick 1 Reply Last reply Reply Quote 0
        • gnydick
          gnydick @dc42 last edited by

          @dc42 I was trying to use all three sliders on the screen.

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA