IRProbe - always in digital mode
-
I am fitting a new IRProbe and it always turns on in digital mode (2 flashes) - i've checked all the wiring with continuity tester at both ends of cable but cannot find a problem - any other troubleshooting tips ?
Thanks
-
Do you have it specified in your config.g using M558 P1 which sets analogue.
-
How have you connected it to the Duet, and how have you configured it in your M558 command in config.g?
-
I cut the ends off a shielded USB cable, crimped three of the four cores and connected to the Z Probe socket on Duet Wifi
M558 P1 X0 Y0 Z0 H6 F200 T5000
G31 X0 Y-20 Z0.57 P500 -
Is the probe working apart from running in digital mode? Are you sure you are using the correct 3 pins of the 4 pin Z probe connector?
-
Yes was working in digital mode - I found the problem - a second M558 in config by mistake -thank you for your help
