BL touch help



  • Hello,

    I mount a bltouch probe on the duet wifi. The bltouch is version 2.1.
    Do I have to cut the copper line on the bltouch logic board to convert it to 3.3 logic or I can leave it as is ?

    I also cannot understand what is the difference between the 2 following modes and if I need to activate one of these 2 (or is done automatically)….
    Probing with Push-pin Down
    Probing with Touch Switch Mode ← only Smart V2.1 and later

    Thanks a lot
    George


  • administrators

    @gbiski said in BL touch help:

    I mount a bltouch probe on the duet wifi. The bltouch is version 2.1.
    Do I have to cut the copper line on the bltouch logic board to convert it to 3.3 logic or I can leave it as is ?

    If it's a version 1.04 Duet WiFi then you don't need to cut that trace. If it's 1.03 or earlier, cut it.


 

Looks like your connection to Duet3D was lost, please wait while we try to reconnect.