short-to-ground / suddenly

CJ.BRAVO

@cj-bravo

I updated to the latest firmware (thought it might help the problem)

dc42

Which Duet? Did you get the error message just once, or does it repeat?

CJ.BRAVO

@dc42

Duet WiFi 1.02 or later + DueX5

when disconnected - the error goes on without the motor.

I rerouted the motor to the DUEX5- it works fine.

error still shows up

CJ.BRAVO

@cj-bravo

error shows up when engaging driver 3.
I've been working with it successfully till now.

duex drivers work fine.

dc42

It sounds like driver 3 has failed. As it's a 1.02 board, I guess it is out of warranty.

CJ.BRAVO

failed ? you mean as in "toast" ?

out of warrany? I just got it like 2 months ago...

Veti

the confusion comes from the fact that you said duet 1.02 which is quite old.

do check the marking on your board and post the real version of it.

CJ.BRAVO

its the duet 2 wifi.

Veti

which version.
you can find the version marked on the board after the string duet2

see https://www.duet3d.com/image/cache/catalog/v104/Wifi_v1.04_above_wb_small-800x800.png

dc42

@cj-bravo said in short-to-ground / suddenly:

failed ? you mean as in "toast" ?

out of warrany? I just got it like 2 months ago...

My mistake, I forgot that the firmware can't tell the difference between 1.02, 1.03 and 1.04 boards. If it's 2 months old, it's in warranty.

CJ.BRAVO

ok i'll contact the supplier...

what could have caused it ? (to avoid from happening again..)

dc42

@cj-bravo said in short-to-ground / suddenly:

ok i'll contact the supplier...

what could have caused it ? (to avoid from happening again..)

A short in the stepper wiring could have caused it. A bad stepper motor connection might possibly cause it, although in my tests I was unable to blow a stepper driver by doing repeated connections and disconnections while the motor was passing 2A current. Incorrect stepper motor wiring (getting the phase wires mixed up) can certainly cause it.

However, a small number of stepper driver chips suffer this kind of infant mortality even if you do nothing wrong. So it it was working normally, you didn't change anything, and the stepper motor wiring is sound, that's probably the explanation.

CJ.BRAVO

ok.

thanks