New Magnetic filament sensor bad?
warpster last edited by
Duet Magnetic Filament sensor...Nothing happens at power on. No LEDs nothing. Is the connector wired inside pin (toward 2 pin connector) to ground, middle pin to 3.3v and outside pin is the output. If so then not much else I can do, it is dead.
Could someone validate the wiring for me? If I have it wired wrong then the docs are wrong....
sorry the documentation was confusing. I have updated it
The original image was from the "top" side of the PCB wich is not the side the headers are on.
I should not edit documentation this tired from ERRF. Updated again, the image is actually correct this time.