Navigation

    Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    [Solved] Diag Light and Unresponsive when SD Card inserted

    Duet Hardware and wiring
    1
    2
    24
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • iratecrayons
      iratecrayons last edited by iratecrayons

      My Duet Maestro crashed when prepping a print this morning, now I have a diag light and fully unresponsive (including serial) when there is an sd card installed. If I remove the SD card everything works, I can even enter all the GCODE from on config.g over the serial line and it seems to be ok.

      I've tried reflashing with BOSSA, replacing the SD card, using the new sd card contents, end result is always the same, diag light on and unresponsive when restarted with an sd card present.

      5v and 3.3v lights are lit.

      If I insert the SD card after restarting, I see this with M122

      Error: SD card speed 30.00Mbytes/sec is unexpected

      Again with any sd card.

      Any other ideas?

      1 Reply Last reply Reply Quote 0
      • iratecrayons
        iratecrayons last edited by

        Well after spending most of the day playing around with no success, a can of compressed air over the board, around the sd card slot and ethernet slot and now it's functional.

        I've tried to remove and reinsert the card a bunch of times, put a small amount of pressure on the card and reader, let it run to warm up a bit, and it still works.

        1 Reply Last reply Reply Quote 1
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA