Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Extruder steps per mm

Locked

Duet Hardware and wiring

2

3

633

Log in to reply

undefined

fcwilt
last edited by

Hi,

On a delta machine, when setting the steps per mm for extruders is the movement measured in relation to the output of the extruder or the output of the nozzle?

Thanks.

Frederick
Printers: A FT-5 with the 713 upgrade bits, a custom MarkForged style, a small Utilmaker style, a small CoreXY from kit and a E3D MS/TC setup. Various hotends. Using Duets (2 and 3) running 3.4.6
1 Reply Last reply
Reply Quote 0
undefined

dc42 administrators
last edited by

It's always the output of the extruder drive.
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com
1 Reply Last reply
Reply Quote 0
undefined

fcwilt
last edited by

@dc42:

It's always the output of the extruder drive.

Thanks much.

Frederick
Printers: A FT-5 with the 713 upgrade bits, a custom MarkForged style, a small Utilmaker style, a small CoreXY from kit and a E3D MS/TC setup. Various hotends. Using Duets (2 and 3) running 3.4.6
1 Reply Last reply
Reply Quote 0

1 / 1