Axis without homing needed
gnydick last edited by gnydick
Is it possible to configure an axis to not need homing? I have 3 x Z motors, but would like to have the U, V, W preconfigured and show up in the DWC.
I've done the latter, as well as set the endstop type for all 3 axes to none, but M564 doesn't take an axis parameter. Is there any way to do this?
A Former User last edited by A Former User
You'll need to home the axis that do need homing, then issue
Veti last edited by
its M564 H0
gnydick last edited by
@Veti that applies to all axes though. I don't want that.
A Former User last edited by
Or use https://duet3d.dozuki.com/Wiki/Gcode#Section_G92_Set_Position on the axis you want to move, as it would be considered homed after