Navigation

    Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    Converting fans to RepRap3

    General Discussion
    3
    5
    36
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • janjoh
      janjoh last edited by

      Hello!

      I am reading https://duet3d.dozuki.com/Wiki/RepRapFirmware_3_overview#Section_M950_Create_heater_fan_or_GPIO_servo_port but I am confused as how to set up my fans.

      Currently with RepRap2 i have

      ; Fans
      M106 P0 S0 I1 F100 H-1 L0.3       ; Set fan 0 value, PWM signal inversion and frequency. Thermostatic control is turned off
      M106 P1 S1 I0 F500 H1 T45       ; Set fan 1 value, PWM signal inversion and frequency. Thermostatic control is turned on
      M106 P2 I1 H100:101 T45:55 L0.3
      

      Now, I understand that I need to define three fans with M950 etc. But I can not find a guide for how to handle the thermostat options. Or maybe it is staring me in the face, and I am missing it?

      1 Reply Last reply Reply Quote 0
      • A Former User
        A Former User last edited by

        You need both 950 and 106 if that wasn't obvious?

        1 Reply Last reply Reply Quote 0
        • dc42
          dc42 administrators last edited by

          Port, PWM frequency and inversion are now set up in the M950 command. Other parameters including thermostatic control are set up in M106 just as in RRF2.

          Duet WiFi hardware designer and firmware engineer
          Please do not ask me for Duet support via PM or email, use the forum
          http://www.escher3d.com, https://miscsolutions.wordpress.com

          janjoh 1 Reply Last reply Reply Quote 0
          • janjoh
            janjoh @dc42 last edited by janjoh

            @dc42 said in Converting fans to RepRap3:

            Port, PWM frequency and inversion are now set up in the M950 command. Other parameters including thermostatic control are set up in M106 just as in RRF2.

            @bearer said in Converting fans to RepRap3:

            You need both 950 and 106 if that wasn't obvious?

            Soooo, I messed my self up by looking for how to convert M106... Yeah, that sounds like me.

            Sorry 🙂

            dc42 1 Reply Last reply Reply Quote 0
            • dc42
              dc42 administrators @janjoh last edited by

              No problem, we're here to help!

              Duet WiFi hardware designer and firmware engineer
              Please do not ask me for Duet support via PM or email, use the forum
              http://www.escher3d.com, https://miscsolutions.wordpress.com

              1 Reply Last reply Reply Quote 0
              • First post
                Last post
              Unless otherwise noted, all forum content is licensed under CC-BY-SA