Duet 2 Maestro No Ethernet

mziminski

I have tried everything I can connect to the Duet 2 Maestro . But I can not get any activity on the Ethernet port.

I know the router and cable is good I have tried it with other devices. I have used yat to turn the port on and off. I tried dhcp and static . I can not get any activity lights off the port at all

Thank Yo

droftarts

@mziminski Hi, sorry you're having problems with your Duet 2 Maestro. If you've followed the guide here https://duet3d.dozuki.com/Guide/1.)+Getting+Connected+to+your+Duet/7#s20 I can't particularly think of any other tests to run; the Ethernet module is quite 'dumb'!

Could you post the YAT output when you turn on/off the Ethernet with M552 S1 P0.0.0.0 (which sets it to DHCP mode) and M552 P0?

Other than that, it's probably a warranty replacement. Where did you buy it from, and when?

Ian

Could be worth trying a fixed speed and duplex setting on router to rule out a compatibility issue as the Maestro doesn't fully support auto mdi/mdx negotiation.

mziminski

i will post yat results when I am near the printer later. But i don't get any lights on the Ethernet port or the router showing it is connected. I have tried enable and disable the port but no lights at all. Almost like the port is disable through a jumper or is just bad.

I have been pulling my hair our since mid december

droftarts

@mziminski Worth trying what @bearer said; check your router setup. Also if it forces large blocks/MTU, as RRF doesn't support that, though I'd expect to the LEDs to light up.

@mziminski said in Duet 2 Maestro No Ethernet:

I have been pulling my hair our since mid december

Sorry for your hair! Next time save your follicles and ask here before you get mad!

Ian

Could well be most consumer routers lack the settings to do such a test, so might be better to try with a direct connection to the computer and trying the settings on the computers adapter.