Maestro auto detect
-
Does the Duet automatically detect the type of hot end fitted? Just set up a Maestro and in Machine Control, tool heater 1 came up as being an E3D V6 without me giving that information. Furthermore without running PID the set temperature holds plus, minus 0.2 degrees, is that just a bit of luck.
-
No auto detect, but the defaults generated are for "most common" setups.
-
@ortondale said in Maestro auto detect:
tool heater 1 came up as being an E3D V6
Post your config.g. Any naming would be present there.
