Runoff 3.3V on expansion socket



  • Hi to all, I bought a pcb relay board as this attached. It runs ok, but I'd like to runoff the psu (so the relais) at end of a print job or remotely instead of by a hand switch on 3.3V wire.
    I check with M81 but it seems that the only way to runoff the relais is putting off the 3.3V. Is there a way, via gcode, to cut 3.3V on expansion socket?
    Anyway, I don't know why this board wants also the ps_on wire.

    Any ideas?

    1817935b-fce9-41ca-8589-a4da9792c216-image.png


  • administrators

    My impression is that you have purchased one of the few relay boards that doesn't have optically isolated inputs; but I can't be certain from the photos you have posted. Please provide a link to the datasheet or seller's page for that relay module.



  • @dc42 said in Runoff 3.3V on expansion socket:

    My impression is that you have purchased one of the few relay boards that doesn't have optically isolated inputs; but I can't be certain form the photos you have posted. Please provide a link to the datasheet or seller's page for that relay module.

    Hello, I finally choosed a simple relay board optically isolated as written in other posts here.

    BTW, this is the link of the object in aliexpress

    https://it.aliexpress.com/item/32974992635.html?spm=a2g0s.9042311.0.0.27424c4dYNXVMk


Log in to reply