Upgrade to 3.0 now bed heater doesn't work
-
I am in the process of trying to upgrade an adimlab printer to duet2wifi. I had the heater working then decided to upgrade the firmware and now it says "no heater found". What would cause this?
-
HAve you done the necessary changes to config.g for RRF3?
Did you get a new config file compatible with RRF3 from the online configurator?
-
That did work. I started tjis a while ago and forgot a few of my steps
It is now starting to heat but giving a fault about heating too slowly
-
Have you done a PID tuning for the bed yet?
-
How is that done? I didn't notice a mention of that step in the set up though i could have very easily missed it. Before the firmware upgrade it would just heat, though slowly.
-