Homing after cancel print RRF 3.0
-
Hi
I recently upgraded from RRF 2 to 3 and after the necessary changes every works except when I pause and cancel a print and try to start a new one...I cannot home and the print will not start. I have to power up and down in order to be able to home and then start a new print.
Is there anything that changed in regard to pause and cancel a print?
start.gG21 ;metric values G90 ;absolute positioning M107 ;start with the fan off G29 S2 M703 ; config filament G28 M376 H10 ;taper off bed level compensation M204 P1200 T2000 ;Set accelerations (mm/s^2) G1 X15 Y5 Z5 G1 Z0.2 F3000 ;move the platform down G1 F3000 G1 X115 Y5 E10 G1 Z21.75 F3000 ;move the platform down G29 S1 pause.g
; pause.g ; called when a print from SD card is paused ; ; generated by RepRapFirmware Configuration Tool on Sat Feb 24 2018 12:46:55 GMT+0100 (Central Europe Standard Time) M83 ; relative extruder moves G1 E-10 F3600 ; retract 10mm of filament G91 ; relative positioning G1 Z5 F360 ; lift Z by 5mm G90 ; absolute positioning G1 X0 Y0 F6000 ; go to X=0 Y=0 cancel.g
does nothingstop.g
M104 S0 ;extruder heater off M140 S0 ;heated bed heater off (if you have it) G91 ;relative positioning G1 E-1 F300 ;retract the filament a bit before lifting the nozzle, to release some of the pressure G1 Z+0.5 E-5 X-20 Y-20 F3000 ;move Z up a bit and retract filament even more G90 ;absolute positioning G1 X0 Y0 ;move X/Y to min endstops, so the head is out of the way Cheers Alex
-
Please try upgrading to firmware 3.01-RC12. There have been many improvements since 3.0.
-
was a bit hesitant to upgrade to an RC...but you would say that RC12 is more reliable than 3.0?
-
@AlexLin said in Homing after cancel print RRF 3.0:
was a bit hesitant to upgrade to an RC...but you would say that RC12 is more reliable than 3.0?
Yes. We are very close to releasing RRF 3.01 stable.
Read the upgrade notes because there are changes to configuration of PanelDue, bed heaters, and (in some cases) endstops.