Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

1LC Toolboard 5V

General Discussion

2

2

127

Log in to reply

undefined

Phospherus
last edited by

Was wondering if on the 1LC toolboard if the 5V regulator could handle a 5V fan?
undefined 1 Reply Last reply
Reply Quote 0
undefined

dc42 administrators @Phospherus
last edited by

@Phospherus said in 1LC Toolboard 5V:

Was wondering if on the 1LC toolboard if the 5V regulator could handle a 5V fan?

It's not intended to, but it would probably be OK if the fan current is low, e.g. 200mA or lower.
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com
1 Reply Last reply
Reply Quote 0

1 / 1