Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    DUET 2 WIFI + EXPANSION BREAKOUT BOARD + AC SERVO DRIVER

    Duet Hardware and wiring
    3
    5
    65
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • MRJEON
      MRJEON last edited by

      I am trying to connect the duet 2 expansion breakout board and ac servo driver. In general, there are six ENA+,- / PUL+,-/ DIR+,-, but I found the wiring for PUL+,- / DIR+,- in the I/O cable of AC SERVO DRIVER, but I can't find ENA+,-. Will AC SERVO run if I connect PUL+,- / DIR+,-?

      1 Reply Last reply Reply Quote 0
      • lance
        lance last edited by

        Servo on

        MRJEON 1 Reply Last reply Reply Quote 0
        • MRJEON
          MRJEON @lance last edited by

          @lance ena+ is servo on? and... What is ena-?

          1 Reply Last reply Reply Quote 0
          • dc42
            dc42 administrators last edited by

            ENA+/ENA- is the Enable signal. Many external drivers (especially servo drivers) don't need it.

            Duet WiFi hardware designer and firmware engineer
            Please do not ask me for Duet support via PM or email, use the forum
            http://www.escher3d.com, https://miscsolutions.wordpress.com

            1 Reply Last reply Reply Quote 0
            • MRJEON
              MRJEON last edited by

              @dc42 said in DUET 2 WIFI + EXPANSION BREAKOUT BOARD + AC SERVO DRIVER:

              ENA+/ENA- is the Enable signal. Many external drivers (especially servo drivers) don't need it.

              ok thanks.

              1 Reply Last reply Reply Quote 0
              • First post
                Last post
              Unless otherwise noted, all forum content is licensed under CC-BY-SA