Problem with emergency buttom
-
When I use this setting for an emergency button, the board locks when it is working.
Is correct it?
M950 J1 C"!^exp.heater4" ; Stop buttom pullup active low
M581 P1 T0 C0 ; Emergency stop on trigger anytimeJose
-
Firmware version? Send M115 to check.
How you format the command will depend on your firmware version.
https://duet3d.dozuki.com/Wiki/Gcode#Section_M581_Configure_external_trigger
-
Thanks you C0 parameter was the problem.
Jose