Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Z creep up after long idling

General Discussion

2

2

362

Log in to reply

Jackal last edited by

I had a few occasion that after leaving my Kossel on for a few hours, when I try to print again the Z seems to be a bit too high (maybe about 0.2-0.4).
0.9 degree motors with Idling current set to 60%.
I would expect the Z to drop instead of moving upwards after long idling, just wondering why this is happening.
1 Reply Last reply
Reply Quote 0
dc42 administrators last edited by

Thermal expansion?
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com
1 Reply Last reply
Reply Quote 0

1 / 1